C-Scope - Duct Sonde (33KHz)

The C.Scope 33KHz Sonde is a small battery powered transmitter which, in typical use, would be screwed onto the end of a duct rod and pushed down a duct so that the direction can be traced using a C.Scope locator set to 'Signal Generator Mode/Transmitter Mode'. The location of a blockage can be identified using this system, with enormous cost saving potential.

• Simple to use.
• Very robust.
• Single AAA battery operation.
• Low battery signal.
• Waterproof to IP65.
• Compatible with most rods.
• Resin sealed electronics.

Construction
• Waterproof, robust plastic, O Ring battery compartment seal, stainless steel end fittings.

Operating frequency
• 32,768 Hz (33 KHz) pulsed.

Range(guide)
• 2 metres

Dimensions
• 24mm diameter, 300mm length.

Fitting
• Standard rod thread (¾" Whitworth 16 T.P.I.), female one end, male the other end.

Battery
• 1 x AAA (IEC type LR03) Alkaline
• Typical battery life 20 hours.
• Battery low indicated by continuous 32,768Hz (33K Hz) signal.

Output Power
• Switchable through four levels up to a maximum of One Watt

Product Dimensions
• 360 x 180 x 230mm

Weight
• 3.4Kg incl. accessories. 2.0Kg unit only.

Batteries
• 4 x D (LR20) alkaline batteries typically giving up to 30 hours intermittent use at 20C.
• Compatible with NiMH rechargable batteries.